Consumables Lubrications And Coolants; Biodegradable Transmission And Hydraulic Oil - New Holland T6.140 Service Manual

Consumables Lubrications and Coolants

Lubrications
The correct engine oil viscosity grade is dependent upon ambient temperature. Refer to the chart when selecting oil
for your tractor engine.
NOTE: In areas where prolonged periods of extreme temperatures are encountered, local lubricant practices are
acceptable; such as the use of SAE 5W30 in extreme low temperatures or SAE 50 in extreme high temperatures.

Biodegradable transmission and hydraulic oil

WARNING
Burn hazard!
Be very careful to avoid contact with hot fluids. If fluid is extremely hot, allow it to cool to a moderately
warm temperature before proceeding.
Failure to comply could result in death or serious injury.
A biodegradable oil has been approved for use in the transmission, 4WD front axle and hubs, and the hydraulic system
of your tractor. Although the oil is 90 % biodegradable, it is important to follow safe handling and disposal practices.
The NEW HOLLAND AMBRA MULTI BIO oil is available from your authorized dealer.
Biodegradable oil should not be used in conjunction with other oils. Use the following procedure to replace standard
oil with biodegradable lubricant.
1. Operate the tractor until the oil that is being changed reaches a temperature greater than 60 °C (140 °F).
2. Stop the engine and immediately drain the oil.
3. Replace all transmission and hydraulic filters.
4. Add the biodegradable oil to the correct level and run the tractor to circulate the oil.
5. Check for oil leaks and recheck the oil level.
INTRODUCTION
1
SS09J076
47665870 27/03/2014
19
W0362A