Fuel filters - Replace
NOTE: There is not a fuel shutoff valve on the fuel tank. To stop the fuel flow from the fuel tank, remove the fuel inlet
hose at the fuel filter base and plug it, or clamp the fuel hose to stop the fuel flow.
1. Close off the fuel inlet hose to the fuel filter.
2. Remove the sediment bowl (1) by rotating the bowl from
the base.
3. Open fuel inlet hose, to drain any remaining water from
the tank.
4. Pull element with plastic base from fuel filter housing
(2) and install a new element.
5. Inspect the O-rings (3) and (4) and replace if necessary.
6. Install and securely tighten the sediment bowl.
7. Open the fuel inlet hose, so fuel will flow to the filter.
8. Bleed the fuel system. See page 7-44.
7 - MAINTENANCE
7-15
1
20100919A