Controller And Sensor Pcb (Lv Connections) - Viessmann Vitocal 222-G Installation And Service Instructions Manual

Compact heat pumps, 400 v~ and 230 v~
Hide thumbs Also See for Vitocal 222-G:
Table of Contents

Advertisement

Electrical connections
Terminals
Function
X3.8
Pressure switch, primary circuit
X3.9
and/or
P
Frost stat
or
Jumper
X3.18
Heat pump control unit power supply
X2.1
230 V~
X1.1

Controller and sensor PCB (LV connections)

Set the required parameters during commissioning:
see page 42 onwards.
Plug
Sensor
F0.1/F0.2
Outside temperature sensor
F0.2/F0.3
Radio clock receiver
F4
Buffer temperature sensor
F11
Contact humidistat 24 V
Note
If the contact humidistat of the NC-Box is used when cooling, set jumper,
otherwise the heat pump will not start (message "CA Protectn device prim-
ry").
F13
Flow temperature sensor, system (downstream of heating water buffer cylin-
der)
F14
Flow temperature sensor, cooling circuit (heating circuit without mixer A1/HC1
or separate cooling circuit SKK)
F16
Room temperature sensor, cooling circuit
Required for separate cooling circuit SKK
Recommended for heating/cooling circuit without mixer A1/HC1
aVG
KM BUS (wires interchangeable)
Use the KM BUS distributor (accessories) if several devices are connected.
KM BUS subscriber (examples):
Extension kit, mixer for heating circuit M2/HC2
Remote control Vitotrol 200A or Vitotrol 300B (set the heating circuit assign-
ment at the remote control)
EA1 extension, AM1 extension
Communication interface Vitocom 100, type GSM2
Modbus 2 (wires not interchangeable)
sVA
Connection for electricity meter of photovoltaic system
J3
Jumper for terminator Modbus 2
Terminator enabled (delivered condition)
Terminator disabled
(cont.)
Explanation
Requires floating N/C contact:
Closed: Continuous safety chain
Open: Safety chain interrupted; heat pump shut down
Breaking capacity 230 V~, 0.15 A
Connection:
Connected in series if both safety components are in-
stalled
Insert jumper if no safety components are instal-
led.
See chapter "Power supply".
Installation sequence
Type
NTC 10 k
Ω
DCF
NTC 10 k
Ω
NTC 10 k
Ω
NTC 10 k
Ω
NTC 10 k
Ω
27

Advertisement

Table of Contents
loading

Table of Contents