Lubrication Maintenance; Greasing Bearings, Bushings & Brake Cables - Toro Groundsmaster 345 Operator's Manual

GREASING BEARINGS, BUSHINGS AND
BRAKE CABLES
The traction unit must be lubricated regularly. If machine
is operated under normal conditions, lubricate all
bearings and bushings after every 50 hours of
operation.
1. The traction unit bearings and bushings that must
be lubricated are: PTO shaft and yokes (Fig. 21); lift arm
pivots (Fig. 22); right and left push arm ball joints
(Fig. 21); push arm pivot bushings (Fig. 23); PTO pivot
housing blocks (Fig. 24); brake pivot bushings (Fig. 25);
rear wheel spindle bushings,steering plate bushings,
axle pin bushing, steering cylinder (2) (Fig. 26) and
engine output shaft bearing (Fig. 27). Also apply grease
to both brake cables at the drive wheel and brake pedal
ends.
Figure 21
Figure 22
Figure 23
22

LUBRICATION MAINTENANCE

Figure 24
Figure 25
Figure 26
Figure 27