Advertisement
6.4
Setting up Message Waiting
Notification
Message Manager's
Main Command Menu
1
2
3
4
5
Setting
M.W.N.
1
2
Assign
Change
Change
Tel No.
M.W.Lamp
Device
Status
Status
Device No.
1
2
Schedule
Continuously
Not Used
Tip:
6.4.2.2 Assigning Notification Numbers
6-8
Message Manager
1-2
Same as the Message Waiting Lamp Status.
3
Press
2
4
Enter the device number.
5
Press
1
3
3
Step 3 -
1
Schedule (enabled on the schedule)
2
Continuously (enabled whole day)
3
Not Used (disabled whole day)
You can set up to three telephone or beeper numbers where
you wish to receive notification. You can use the keys '0'
to '9', a tone/pulse switch, and the beeper callback number
display entry code 'X'.
If you add the Beeper Callback No. Entry Code at the end of
a beeper number, the notification is made in a little different
way. The VPS asks the caller to enter the number to which
he wishes to be called and displays it on the LCD of your
beeper. The timing of the callback number entry is either
before, after or without recording message. It depends on
System Programming.
It is also possible to have the caller select whether or not
enter the number.
You must have your System Manager authorize the use of
the Beeper Callback No. Entry Code.
1-2
Same as the Message Waiting Lamp Status.
3
Press
3
to change the way of notification.
–
3
to select the status.
to assign the telephone number.
Advertisement
Chapters
