Removal Of Operation Guide - Toto WASHLET SW4547AT60 Instruction Manual

What to Do?
Follow the procedure below.
How to remove the operation guide
1
Remove the cover on the left side of the main unit, and fl ip the power
switch to "OFF".
(Page 15)
2
Remove the remote control from the hanger.
(Page 14)
3
Remove the hanger and
operation guide.
4
Screw the hanger on the wall.
5
Mount the remote control in the hanger.
6
Flip the power switch to ON.
• The "Power" LED lights up.
7
Reinstall the cover.
(Page 31)
■ To install back the operation guide, follow the procedure above.
(Install the operation guide at step
62

Removal of Operation Guide

Phillips screwdriver
Screw
Hanger Operation guide
(Page 15)
.)
4
Troubleshooting
First, try the actions described on pages 63 - 69. If the problem persists, consult the installer, seller, or TOTO
customer service (see contact information on the back cover).
Please check fi rst
■ Is the breaker on the distribution board turned on?
➞Check whether there is a power outage or the breaker has turned "OFF".
Is the Power LED lit?
■ Is the power switch fl ipped to "OFF"?
➞Flip it to "ON". (Page 15 Step 2-2)
■ Is the "Power ON/OFF" setting "OFF"?
➞Switch it to "ON" with the remote control. (Page 15 Step 2-2)
■ While the LED is lit, energy saver
so the toilet seat temperature may be reduced or the
Is the Energy saver
heater may be turned off.
LED lit?
■ Does the display screen
on the back of the remote
Is the remote
show "
control working?
➞Replace the batteries. (Pages 14, 58)
■ Is the remote control
transmitter or the remote
control receiver blocked?
➞Remove obstructions, dirt, water
droplets or any other blockages.
Remote control
transmitter
CAUTION
If a water leak occurs, close the shutoff
valve.
is in operation,
(Page 26)
The remote control
batteries
uses
"?
to operate.
Remote control receiver
63