Maintenance
Gap between the Main Unit and the Toilet Lid
The toilet lid can be removed for thorough cleaning.
Remove the cover on the left
1
side of the main unit, and flip
the power switch to "OFF".
(Page 30)
2
Remove the toilet lid.
Strongly pull it out, starting with
and finishing with
.
3
Wipe with a soft cloth that has
been soaked in water and
wrung out thoroughly.
4
Reinstall the toilet lid.
Insert
and then
into the pins.
* Do not use excessive force.
5
Flip the power switch to ON.
(Page 30)
• The "Power" LED lights up.
6
Reinstall the cover.
(Page 31)
7
Open and close the toilet lid
to check the reinstallation.
36
Gap between the Main Unit and the Toilet Lid
(Approximately once a month)
Soft cloth soaked in
Toilet paper, etc.
water
(May cause damage.)
Removing and Reinstalling
Use the appropriate
angle.
Vertically
90°
Hold with
both hands
Pin
Water Filter Drain Valve
Water Filter Drain Valve
1
Close the shutoff valve.
• The water supply stops.
CAUTION
Do not remove the water filter drain
valve while the shutoff valve is open.
(Otherwise, water may leak out)
2
Press "Wand CLEAN"
button.
(Release the pressure from the water
supply pipe.)
3
Remove the cover on the left
side of the main unit, and flip
the power switch to "OFF".
(Page 30)
4
Remove the water filter drain
valve.
• Loosen the water filter drain valve with a
flat-head screwdriver and then pull it.
Water filter drain valve
Pin
Flat-head screwdriver
(Approximately once every 6 months)
<If you think the water pressure has weakened>
5
Clean the filter with a tool
(Page 63)
such as a toothbrush.
• Also, remove any dust from inside the hole
of the water filter drain valve.
6
Reinstall the water filter drain
valve.
• Insert the water filter drain valve and use a
flat-head screwdriver to tighten it securely.
7
Flip the power switch to ON.
(Page 30)
• The "Power" LED lights up.
8
Reinstall the cover.
9
Open the shutoff valve.
Filter
(Page 31)
(Page 15)
37