Sony DVS-7200A Operation Manual page 48

Location and Function of Parts
7 PGM (program) OUTPUTS 1 to 4 connectors
(BNC type)
These connectors output the final program signal in
either serial digital or analog composite format.
Program monitors, VTRs, etc. can be connected.
8 PVW (preview) OUTPUT connector (BNC type)
This connector outputs the preview signal
corresponding to the final program signal in either
serial digital or analog composite format. A preview
monitor or other equipment can be connected.
9 DIRECT INPUT connector (BNC type)
This connector takes as input the final output signal
from an external device, in serial digital or analog
composite format. The input signal is then output
from the EDIT PVW OUTPUT connector by relay
switching. (Since noise is generated by the switching,
this is not suitable for use by the main signal.)
Rear panel (right side)
12(E)
0 CLEAN OUTPUT connector (BNC type)
The final signal is output from this connector prior to
key processing. Also, by changing settings, it is
possible to output preview signals or key signals that
have been processed for output.
!¡ EDIT PVW (preview) OUTPUT connector
(BNC type)
The signal selected by the edit preview bus is output
from this connector in serial digital or analog format.
1 CRK INPUTS 1 to 4 connectors
2 GPI connector
3 TERMINAL connector
4 SERIAL TALLY connector
5 PANEL 1 connector
6 REF INPUTS connectors
7 REF OUTPUT connector
8 DME 1 to 4 connectors
9 EDITOR A and B/ REMOTE 1 and 2 connectors
0 REMOTE 4 connector
!¡ MATRIX connector
!™ PANEL 2/ REMOTE 3 connector