Sony DVS-7200A Operation Manual page 47

Rear panel (left side)
1 ⁄AC IN A and B connectors
2 y (signal ground) terminal
3 PRIMARY INPUTS 1 to
36 connectors
4 AUX BUS OUTPUTS 1 to
13 connectors
1 ⁄AC IN (AC power input) A and B connectors
(3-pin)
Connect to a 100 to 240 V AC power source with an
optional AC power cord. As shipped, the A connector
supplies power to the built-in power supply unit. If the
optional BKDS-7690 unit is installed, both the A and
B connectors can be used.
For more information on the BKDS-7690, contact your Sony
representative or qualified Sony service personnel.
2 y (signal ground) terminal
Connect to the system ground as required.
3 PRIMARY INPUTS 1 to 36 connectors (BNC
type)
By installing optional BKDS-7103 boards and/or
BKDS-7110 + BKDS-7113 boards, up to 36 channels
of serial digital input signal can be connected. Also,
by installing optional BKDS-7110 + BKDS-7111
boards, up to 36 channels of analog composite video
input signal can be connected.
5 ME-1/ME-2 OUTPUTS
connectors
6 DSK PGM OUTPUTS
connectors
7 PGM OUTPUTS 1 to 4
connectors
8 PVW OUTPUT connector
9 DIRECT INPUT connector
0 CLEAN OUTPUT connector
!¡ EDIT PVW OUTPUT connector
4 AUX (auxiliary) BUS OUTPUTS 1 to 13
connectors (BNC type)
These outputs are used for auxiliary digital/analog
output to external devices such as a digital multi
effects unit or digital multi-keyer. Use the control
panel to set the signal assigned to each bus.
5 ME-1/ME-2 OUTPUTS connectors (BNC type)
The images operated on by the control panel's M/E
banks 1 and 2 are output as either serial digital or
analog composite signals. The image being operated
on can be viewed by connecting program monitors to
these connectors.
6 DSK PGM (program) OUTPUTS connectors
(BNC type)
These connectors output as serial digital video or
analog composite video signals the same video as the
PGM OUTPUTS connectors 7.
When using the 2-M/E panel (in a DVS-7200A
system), the optional BKDS-7340 DSK Control Panel
Unit is required to use the output of these connectors.
11(E)