Canon N1000 User Manual page 60

Ext. Network
Maint. Setup
Cleaning at ON
Panel Reset
Panel Reset
4-12
Using the Operation Panel
Menu Item
Init. Settings
Set TCP/IP
Regis. Settings
*1. If the date and time setting of the computer where the printer is connected are
not correct, the printhead may clean itself too frequently and waste ink. Make
sure that all the date and time settings on the computer are correct.
Available Settings
Frame Type: Disable, Ethernet II
IP Mode: Manual*, Automatic
Protocol
DHCP: On*, Off
BOOTP: On*, Off
RARP: On*, Off
IP Setting
IP Address
Subnet Mask
Default G/W
On*, Off
Functions
Executes the initial settings for the
"Ext. Network" menu.
Allows selections to set up the TCP/
IP network information for the
network interface board. After
selecting a setting for each TCP/IP
item, execute "Regis. Settings" to
enable the values selected.
Registers the TCP/IP settings
selected above for the network
interface board.
Determines whether or not the
printhead is cleaned when the printer
*1
is powered on.
Initializes the operation panel menus
and restores the default settings. A
panel reset does not affect the "Ext.
Network" settings.