Table of Contents
Advertisement
CHAPTER 2
HARDWARE INSTALLATION
2.11 Remote Power On/Off Switch: JRMS1
Connect to a 2-pin push button switch. If Instant-on is Enabled, every time
the switch is shorted by pushing it once, the power supply will change its
status from OFF to ON. If Instant-on is Disabled: During ON stage, push
once and the system goes to sleep mode: pushing it more than 6 seconds
will change its status from ON to OFF. If you want to change the setup,
you could go to the BIOS Integrated Peripherals Setup. This is used for
ATX type power supply only.
JRMS1
2-25
Advertisement
Table of Contents
