Honeywell Notifier LCD6000N Installation Manual page 3

NOTE: Do not try to install the LCD6000N without having read this manual.
WARNING: This manual refers to all the features available in software revision
indicated on manual's cover.
A security or fire detection system is useful for timely advice of each dangerous event, like fire, theft,
intrusion and in some cases can provide automatic event management (evacuation messages diffusion,
automatic extinguishing systems, CCTV plants interfacing, door and accesses lock, automatic warning of
authorities etc.) but in any case, does not assure protection against property damage or resulting from fire or
theft in general. Each system also can not function properly if not installed and maintained according to
manufacturer's instructions.
PRECAUTIONS

These instructions contain procedures to follow to avoid devices damages. We assume that the
user of this manual has previously attended a course and knows applicable laws and
regulations.

The system and devices must be installed in an environment with the following characteristics:



Devices (sensors etc.), not perfectly complying with the control panel can cause damages to the
control panel or system malfunctioning, and this could even happen at the worst time. That's
why it's essential to use only material that is indicated by NOTIFIER as compatible with its
control panels. In case of doubt check with NOTIFIER technical assistance.

This system and all its solid state components, can be damaged by induced electrostatic
discharges: handle the boards picking them on borders and avoid to touch electronic
components.

A good grounding connection ensures noise sensitivity reduction

Consult Technical Service NOTIFIER if you are unable to solve installation problems

Any electrical system requires proper power supply. Whether mains is missing, the system can
work with backup batteries, but only for a limited time.

During plant's programming, consider required autonomy in order to choose the correct power
supply and battery

Periodically check batteries' level by qualified personnel

Disconnect mains and batteries BEFORE removing or adding any board

Disconnect all power sources, BEFORE performing any service operation

Control panel and connected devices (sensors, modules, annunciators etc.) can be damaged if
a board is inserted or removed, or if cables under voltage are connected.

The most common cause of malfunctioning is bad maintenance

Take care of these issues particularly from the stage of system design, to facilitate and thereby
reduce the future cost of interventions
This device is marked CE, to certify its quality and compliance with European community's regulations

Electromagnetic Compatibility Directive 89/336/EEC (and 92/23/EEC directive)

Low Voltage Directive 73/23/EEC
LCD6000N
LCD6000N_manu-inst
DETECTION SYSTEM LIMITS
Temperature: -5°C to +40°C
Humidity: 10 % - 93 % (without condensate).
Installation Manual
Doc. M-183.1-LCD6000N-ENG Rev A.2
PAGE - 1
NOTIFIER ITALIA