Table of Contents
Advertisement
– Turn the choke shaft until the
choke shutter is closed.
: Remove the screw (arrow).
1
– Turn the choke shaft a little and
take out the shutter (1).
1
: Remove the E-clip (arrow).
– Pull out the choke shaft (1) in the
direction of the lever. Disconnect
and relax the torsion spring at the
same time.
MS 171, MS 181, MS 211
All manuals and user guides at all-guides.com
– Check the choke shaft (1) and
torsion spring (2) and replace if
necessary.
: Note installed position (arrow) of
torsion spring (2).
– Clean the choke shaft and
guides, b 16
– Install in the reverse sequence.
The throttle shaft is shown without
the lever for reasons of clarity.
: Push the choke shaft (1) into the
carburetor.
: Position the torsion spring (2) on
the throttle shaft (arrow).
2
1
1
: Fit the E-clip (arrow) and let go of
the choke shaft.
2
: Turn the choke shaft (1) counter-
clockwise until its flat side faces
forwards – choke shaft is now
preloaded.
1
1
81
Hide quick links:
Advertisement
Table of Contents
