Table of Contents
Advertisement
1
The ignition module (1) and ignition
lead (2) are an assembly.
– Check the ignition module (1) and
ignition lead and replace the
ignition module if necessary.
2
: Remove the insulator (1) and pull
off the retainer (2).
– Check the retainer and insulator
and replace if necessary.
– Check the spark plug boot and
replace if necessary, b 9.4
– Troubleshooting, b 4.5
1
: Fit the retainer (1).
MS 171, MS 181, MS 211
All manuals and user guides at all-guides.com
2
2
– Fit the insulator (1) so that the
stop (2) is against the upper hole.
: Secure the insulator (1) with the
lugs (arrows) on the bosses.
2
1
1
: Position the ignition module (1)
so that the ignition lead (2) is on
the left and insert the screw
(arrow) with washer
– do not tighten down yet.
1
: Fit the wire terminal (1) so that it
is against the stop (arrow) and
insert the screw – do not tighten
down yet.
1
1
: Fit the ground wire (2) in the
retainer (1) – ground wire must
face the cylinder (arrow).
N
– Push the ignition module (1) back
– the flywheel must turn freely.
: Rotate the flywheel until the
magnet poles (arrows) are next to
the ignition module.
2
1
41
Hide quick links:
Advertisement
Table of Contents
