Stihl MS 171 Manual page 66

1
: Pass the lever (1) under the
crossmember (arrow) and
position it at an angle.
1
: Place the switch shaft (1) in
position and engage it in the
lever's pivot pins (arrows).
1
: Line up the switch shaft (1) and
push it into the right-hand mount
(arrow).
– Position the switch shaft and
lever against the mounts.
MS 171, MS 181, MS 211
All manuals and user guides at all-guides.com
1
: Apply screwdriver to ledge
(arrow) above the switch shaft
(1).
: Ease the switch shaft (1) into the
guide until it snaps into position.
: Insert screwdriver through
opening in the lever (1) and apply
it to the edge (arrow).
: Push the lever (1) into the mounts
until it snaps into position.
1
: Push connector of short circuit
wire (1) into the receptacle on the
switch shaft (arrow) as far as
stop.
1
The short circuit wire must be
looped (arrow) so that it can move
with the switch shaft.
The wires must be laid close to the
housing and properly seated in the
guides.
65