Table of Contents
Advertisement
Standard Starter Grip
– Pull the old rope out of the starter
grip.
: Tie one of the special knots
shown in the end of the new rope.
– Thread the starter rope through
the top of the starter grip.
: Pull the starter rope through the
grip until the knot is seated in the
recess (arrow).
56
All manuals and user guides at all-guides.com
Elastostart Starter Grip
1
: Use a suitable tool to pry the cap
(1) out of the starter grip.
: Pull the sleeve, washers, spring
and rope (arrow) out of the grip.
– Pull any remaining rope out of the
sleeve. Inspect the individual
parts and replace if necessary.
Do not shorten the starter rope.
1
– Thread the new starter rope
through the sleeve.
– Tie a simple overhand knot in the
end of the rope.
– Fit the washers and spring.
: Pull the starter rope with sleeve,
spring and washers into the
starter grip (1).
Make sure the washers and spring
remain on the sleeve while the rope
its being pulled into the grip.
– Position cap so that its lug
engages the slot in the starter
grip.
– Press the cap into the starter grip.
1
: Thread the starter rope (1)
through the guide bushing
(arrow).
MS 171, MS 181, MS 211
Hide quick links:
Advertisement
Table of Contents
