Before Starting The Machine - MTD HT 51 E Manual

Use safety glasses. Also use face or dust mask
if the cutting operation is dusty.
Do not abuse the cord. Never carry the tool
by the cord or yank it to disconnect it from the
socked. Keep the cord away from hear, oil and
sharp edges.
Connect dust extraction equipment.
If device are provided for the connection of the
dust extraction and collection facilities ensure
these are connected and properly used.
Secure work.
Use a clamps or a vice to hold the work, it is
safer than use your hand and it free both hands
to operate the tool.
Remove adjust key and wrenches.
Form a habit of checking to see that keys and
adjusting wrench are remove from the tool before
turning it on.
Do not overreach. Keep proper footing and
balance at all times.
Maintain tools with care. Keep cutting tools
sharp and clean for better safe performance.
Follow instructions for lubrication and changing
accessories. Inspect tool cord periodically and if
damaged have it repaired by an authorized service
facility. Inspect extension cords periodically and
replace; if damaged. Keep handles dry, clean and
free from oil and grease.
Switch off the tools. When not in use, before
servicing and when changing accessories such
as blades, bits and cutters.
Avoid unintentional starting. Do not carry a
plugged-in tool with a finger on the switch. Ensure
switch is off when plugging in.
Use outdoor extension leads. When tool is
used outdoors, use only extension cord intended
for outdoor use.
Stay alert. Watch what you are doing. Use common
sense. Do not operate tool when you are tired.
Check damaged parts. Before further use of
the tool, a guard or other part that is damaged
HEDGE TRIMMER USER MANUAL
should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, free running
of moving parts, breakage of parts mounting and
any other conditions that may affect its operation.
A guard or damaged should be properly repaired
or replaced by an authorized service center unless
otherwise indicated in this instruction manual.
Have defective switches replaced by an authorized
service facility. Do not use the tool if the switch does
not turn it on and off.
Warning. The use of any accessory or attachment,
other than those recommended in this instruction
manual, may present a risk of personal injury.
Have your tool repaired by a qualified person. This
electric tool is accordance with the relevant safety
requirements. Repairs should only be carried out
by qualified persons using original spare parts,
otherwise this may result in considerable danger
to the use.
If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent;

4. Before starting the machine

Connection
This hedge trimmer may only be connected to
single-phase AC current. Ensure that the mains
voltage is the same as the operating voltage
indicated on the rating plate.
Connect the power plug to the coupling of an
appropriate extension cord. Form a loop, push it
through the opening in the rear handle and hook
over the cable holder (6).
Mounting the hand guard
- Push the supplied hand guard (3) over the blades
and fix securely with each screws (8) on both
sides of the housing as showed in drawings.
GB
33