Remote Control Installation - Trane LCD Control Series Owners & Installation Manual

Remote Control Installation Location
Both of display unit and receiver can be installed within
the maximum length cable of 15 meters.
- The display unit and receiver should be located on
the wall approximately 150 clearly visible from most
locations in the conditioning space.
- Do not place the remote control near heat sources or
exposed to the direct rays of the sun.
- Do not place in a confined stream.
Cable Routing
- Connect either terminal to connector P10 at the
printed circuit board and the other to Display unit
(wall mouth).
- The cable should be installed and routed in the area
that not exposed to excessively hot temperature,
moisture, sharp edges and moving surface.
Install the wireless remote control and wired control as
follows:
Locate and attach the wireless remote control and
wired control as follows:
1. Do not place the control and the remote control
near heat sources or expose to the direct rays of
the sun.
2. Do not expose the control to the indoor unitís supply
air stream.
3. Do not place in a confined space.
4. Attach the remote control holder as shown in Figure 10.
24

Remote Control Installation

Wireless Remote Control
Figure 10
ACYSTAT-IOM-EN