Table of Contents
Advertisement
6 - CLEANING AND MAINTENANCE
GENERAL ADVICE
•
Before you begin cleaning, you
must ensure that the appliance is
switched off at the cooker switch.
•
It is advisable to clean when the
appliance is cold and especially when
cleaning the enamelled parts .
•
Avoid
leaving
substances (lemon juice, vinegar, etc .)
on the surfaces .
•
Avoid using cleaning products with
a chlorine or acidic base.
Important: The use of suitable
•
protective
recommended when handling or
cleaning this appliance.
•
Under no circumstances should
any external covers be removed for
servicing or maintenance except by
suitable qualified personnel.
WARNING:
When correctly installed, your product
meets all safety requirements laid down
for this type of product category.
However special care should be taken
around the rear or the underneath of
the appliance as these areas are not
designed or intended to be touched and
may contain sharp or rough edges, that
may cause injury.
Important: The manufacturer declines all liability for possible damage caused by
the use of unsuitable products to clean the appliance.
Attention!
The appliance gets very hot, mainly around the cooking areas. It is very important
that children are not left alone in the kitchen when you are cooking.
Do not use a steam cleaner because the moisture can get into the appliance thus
make it unsafe.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door
glass since they can scratch the surface, which may result in shattering of the
glass.
46
46
alkaline
or
acidic
clothing/gloves
•
Cleaning electronic programmer
display:
display using a soft cloth, warm water
and neutral soap, or a soft cloth with a
liquid detergent (non-abrasive) . When
cleaning, be careful to move the cloth
in one direction only . Then wipe the
display with a damp cloth and dry it
with a soft cloth .
IMPORTANT: DO NOT use chlorine-
based
products, abrasive products or
non-neutral detergents as they may
is
cause irreparable damage to the
surface. DO NOT spray cleaning
liquids directly on the programmer
display.
•
Stainless steel hob: Spillage on
the hob can usually be removed by
a damp soapy cloth . More obstinate
stains can be removed by using a
proprietary stainless steel cleaning
product that does not contain chlorine
or acidic base .
•
Control panel facia: Clean very
carefully with water and neutral soap;
the cloth used must be rinsed well and
must be free of any cleaning chemicals
to avoid damaging any screen print on
the facia
Clean
the
programmer
or
acid-based
cleaning
- Quick Links:
- Electrical Section
Hide quick links:
Advertisement
Table of Contents
