Prompt For Additional Channels; Reselect The Driver For Additional Channels - 3Com 3C971-F ATMLINK User Manual

Figure 4-15 Prompt for Additional Channels
10 Do one of the following:
Select No to exit the configuration procedure, and
go to the next section ("Editing the AUTOEXEC.NCF
File") to continue the installation.
Select Yes to configure an additional channel. The
maximum is four channels (Channel 1 plus three
additional channels).
The dialog box in Figure 4-16 appears.
Figure 4-16 Reselect the Driver for Additional Channels
The dialog box in Figure 4-16 is the same dialog
box as shown in Figure 4-6. However, this time the
driver is obtained from the NetWare server's hard
disk instead of the installation diskette. Each
channel requires the installation and configuration of
a 3C971-F adapter driver.
11 Select the 3C971FSI.LAN in the driver selection
dialog box shown in Figure 4-16.
Configuring Network Channels 4-13