System Requirements; Loading The Novell Netware Server Driver - 3Com 3C971-F ATMLINK User Manual

4-2 C 4: N
HAPTER ET
Verify the system requirements.
Copy the drivers to the hard drive of the server.
Configure the single-LAN or multi-LAN parameters.

System Requirements

An Intel x86-based file server running Novell
NetWare Version 4.1
16 MB of system memory, 24 MB recommended
A 3.5 inch floppy disk drive

Loading the Novell NetWare Server Driver

The procedures within this chapter assume the
3C971-F adapter is already installed in the
workstation. If the adapter is not installed, refer to
Chapter 2 for hardware installation instructions.
CAUTION: If a 3C971-F adapter driver is already
installed in the server, you must remove it before
proceeding with this installation. Refer to the section
"Removing a Driver from NetWare" at the end of this
chapter for instructions.
Follow the steps below to install the 3Com 3C971-F
adapter driver on a NetWare 4.1 file server:
1 With NetWare 4.1 installed and the server up and
running, enter the following command at the
prompt:
load install
The NetWare Installation Options dialog box appears,
as shown in Figure 4-1.
W 4.1 S D
ARE ERVER RIVER
I
NSTALLATION