3Com 3C971-F ATMLINK User Manual page 38

3-16 C 3: W NT D I
HAPTER INDOWS RIVER NSTALLATION
Adapter Device Driver." A default setting of Auto
Detect was recommended in that step.
The Interrupt entry in the LEC Configuration dialog
box is not "in addition" to the entry in the previous
PCI Adapter Setup dialog box. The edit is made
available in the LEC applications to give the user an
opportunity to change the interrupt setting after the
driver is installed. The PCI Adapter Setup dialog box
is not accessible by the user after the first reboot of
the computer.
6 Select the Configure button.
The dialog box in Figure 3-11 allows the user to set
the 3C971-F adapter to communicate with up to four
LAN emulation servers. Four MAC addresses
appear in the Client List box. The first, Client 0, is
the default MAC address of the 3C971-F adapter.
The other three MAC addresses are increments of
the default address. All settings in the LEC ATM
Adapter Configuration dialog box are tied to the client
highlighted in the Client List box.
If the 3C971-F adapter is to communicate with only
one LAN emulation server, then Client 0 is the only
client that needs to be configured. The remaining
three clients must be disabled. The default settings
for Client 0 that initially appear in the dialog box are:
Enable: Enabled (Client 0 cannot be disabled)
MTU Size: 1514 (recommended for communicating
with Ethernet hosts)
ELAN Name: (blank)
LECS/LES: set to contact the LECS
ATM Address: set to the ATM Forum's "well-known"
address