Table of Contents
Advertisement
CASSETTE HOUSING CONTROL ASSEMBLY
Removal
Set the cassette ejected condition in the cassette
eject mode.
2.
Unplug the recorder from the main source.
3.
Follow the procedures below in the specified
order.
a) Remove the cassette loading belt 0.
b) Disconnect the FFC (full Flat Cable) 8.
c) Remove the cassette housing installation
screws 0.
d) Slide and pull out the cassette housing control
assembly upward @I.
Figure 1-l.
1. Before installation of the cassette housing
control assembly, place the unit in the stop mode
with the power on, then unplug the power cord.
(The main body is placed in the eject mode.)
2. Follow the procedures for removal in the reverse
order.
Notes:
1. Be sure to unplug the power cord in removal and
reassembly.
2. Keep the cassette loading belt free from grease.
In case of its adhesion, clean the belt.
3. In using a magnet screw driver, be sure to keep it
away from
the drum.
4. In removal and reassembly, take care not to hit
the
housing control assembly or tools
a g a i n s t t h e g u i d e p i n , d r u m , o r t h e l i k e
thereabout.
s e t s c r e w
Insert the tab of
the cassette hosing
control assembly to
the mechanism chassis.
Cassette housing
Place the unit in the eject mode in removal or
5.
reassembly of the cassette housing control
assembly.
6.
Load the cassette once onto the cassette housing
c o n t r o l
cassette housing control assembly normally
operates after this, the phases of mechanism and
the
controller are accurately adjusted
after ejection.)
MECHANICAL OPERATION CHECK
WITHOUT CASSElTE
When power is on, the general operations of the
mechanism can be checked without a cassette.
Note the following points.
1. Check video search rewind and rewind, rotating
the take-up reel disk @ by hand (in either
2. When the stop button is pressed, the mechanism
stop at a normal stop position. It shifts
to the eject mode and stops.
3. When the stop button is pressed in the playback,
video search rewind, and video search forward
modes, the supply reel disk 0 keeps on rotating
for several seconds for elimination of tape slack
in the course of shifting to the eject mode. In
such a case, rotate the take-up reel disk @
somewhat by hand, and the supply reel disk 0
stops, which can reduce the working time.
, E IVI c IY I
ASSEMB LY
Cassette housing frame (R)
Figure l-2.
11
after reassembly. (If the
Advertisement
Table of Contents
