Table of Contents
Advertisement
Remove the slow brake spring 0.
Remove the slow brake shaft cap 8.
3.
Remove the slow brake lever a.
4.
Remove the E ring @.
5.
Rotate the take-up loading gear, take-up
loading arm assembly, supply loading gear and
supply loading arm assembly slightly in the
loading direction, and take them @ all out.
6.
Remove the E ring a.
7.
Remove the relay gear drive lever a.
Reassembly
Reverse the procedure. Be sure to match the
tally marks on the gears.
Figure 1-66.
Notes :
1. When reassembling, apply specified grease to
the following points; all the gear teeth, all the
gear shafts and the cam groove of loading
relay gear.
2. Be careful not the deform the supply/take-up
loading arms.
3. Be careful to keep clean the slow brake lever
felt.
4. Be also careful to keep the outer surface of
the capstan D.D. motor free from dust and
dirt. (If stained, the MR (Magnet Resistor)
element might be damaged.)
5. Take care not to deform the anti-fall hooks of
loading gears more than required.
REMOVAL AND REASSEMBLY OF LOADING
BLOCK
2. Remove the cassette loading belt 8
3. Unscrew the three screws a.
block upward.
4. Pull the loading
Note :
When using a magnetic screw driver in removal
of three screws, do not allow the magnetic driver
to hit the A/C head or drums.
Reassembly
l
1. Turn the master cam all the way counter-
clockwise.
2. Match the tally mark on the cam switch with the
mating mark. Fit the loading block and the
with
master cam
three screws.
3. Finally connect the leads and apply the cassette
loading belt.
Notes:
2. Be careful not to stain the belt. If dirty, clean it
with the specified
up
REPLACEMENT OF LOADING MOTOR
1. Set the cassette ejected condition by placing the
unit in the cassette eject mode.
2. Unplug the power cord.
3. Remove the loading block in accordance with
the statements and drawings above.
29
Master
Figure l-67.
each other. Tighten up the
C a m swnch
Figure l-68.
cleaning liquid.
Advertisement
Table of Contents
