Table of Contents
Advertisement
1. Unsolder the cassette switch connectors (No. 16,
17) from the stat-t sensor PWB.
connector
Figurer
2. Lift the start sensor PWB pressing the two start
sensor PWB fixing hooks inward.
Figure l-4.
3. Unscrew one B tight screw to detach the worm
bracket.
Note: The worm shaft bearing can easily come
out of position. So be careful not to lose
it.
Figure l-5.
4. Remove the worm shaft assembly, pulley, and
cassette loading belt all from the cassette
housing frame (R).
Worm shaft ass' y
Worm wheel ass' y
Figure l-6.
Start sensor
PWB
fixing hook
Start sensor PWB
bracket
-Cassette
hosing
frame (R)
12
5. Place the slider pin just above the worm wheel
(Figure l-7). (The retainer of the slider is locked
at two positions hen. So unlock it as in the
Figure l-8.)
6. Pull out the worm wheel assembly toward you
pressing the switch lever upward. (Figure l-7)
Cut washer
Figure l-7.
Retainer opening
(Also provided on the IL) side
of cassette housing frame)
Cassette housing
Press.
Cassette housing frame
Figure 1-8.
l
Reassembly
1. Turn the phase gear clockwise until the slider
comes to a halt in the cassette insertion
direction. (See the Figure l-9.)
2. Insert the set up worm wheel gear assembly into
the cassette housing frame (R), matching the
mark on the phase gear with the mark on the
worm wheel gear. Detach the cut washer on the
phase gear assembly and the phase gear for
easier installation of worm wheel assembly.
Note: Make sure that the slider pin is in the
groove of the drive gear arm.
Retainer
Advertisement
Table of Contents
