Table of Contents
Advertisement
CHECKING AND ADJUSTMENT OF RECORD
Remove the cassette housing control assembly.
l
Cassette torque meter
Push the record button
to place the unit
Figure l-40.
1. Put a cassette torque meter into the unit.
2. Push the record button to place the unit in the
record mode.
3. Check that the back tension indicated by the
gauge is within the set range 31 to 36 g.cm.
Notes :
1. Make sure that the video cassette tape is over
the retaining guide.
2. Make sure that the tape is not slack nor
damaged at either end.
Adjustment
l
than specified, move the tip of the tension spring
hook pIaYe toward the hole A.
2. If the reading of the cassette torque meter is
more than specified, move the tip of the tension
spring hook plate toward the hole 6.
it toward you, and turn it for easer shift of the
tension spring hook plate in the direction of A or
B.
Figure 1-41
Open here
chassis
CHECKING THE BRAKE TORQUE
l
Checking the brake torque at the supply side
hook plate
22
Figure 142. Not used.
T o r q u e
,-Supply reel disk
Figure
143.
Supply reel
disk
Advertisement
Table of Contents
