Table of Contents
Advertisement
Here we will describe a relatively simple service
w o r k i n t h e f i e l d , n o t r e f e r r i n g t o t h e m o r e
complicated repairs which would require the use of
special equipment and tools (drum assembly
replacement, for example).
TOOLS NECESSARY FOR ADJUSTING THE MECHANICAL UNITS
The following tools are required for proper service and satisfactory repair.
Jig Item
Gauge Head
5
Cassette Torque Meter
6
Tension Gauge (3009)
7
Hex Wrench (0.9mm)
8
Hex Wrench (1.2mm)
Hex Wrench (1.5mm)
Alignment Tape (PAL)
9
Alignment Tape (NTSC)
0
Drum Replacing Jig
ADJUSTMENT, REPLACEMENT AND ASSEMBLY
OF MECHANICAL UNITS
J i G T H 0 0 0 6 AW
J i G H W 0 0 0 9 A E
JiGHWOO12 AE
JiGHWOO15 AE
V R O C P S V C D
V R O A T S V C D
We are sure that the easy-to-handle tools listed
below would be more than handy for periodical
maintenance to keen the machine in its oriainal
working condition.
Configuration
F
S
G
8
Remarks
I
These Jigs are used for checking and
adjusting the reel disk height
This Jig is used for setting the A/C
These Jigs are used for checking and
adjusting the torque of take-up and
This cassette torque meter is used
for checking and adjusting the
torque of take-up for measuring
tape back tension.
There are two Gauges used for the
These Jigs are used for loosening or
tightening special hexagon type
screws.
These tapes are especially used for
electrical fine adjustment.
This is used for replacement of the
VCR' s upper drum.
Advertisement
Table of Contents
