Table of Contents
Advertisement
adjust the height
Roughly
of the AK head by turning
the AK head adjusting
hexagon nut with the
specialized box driver until
the tape is in the position
shown below.
Adjust the nut visually so that J
the control head IS visible 0.3
of the tape.
Figure l-50.
GUIDE AND REVERSE GUIDE
Note :
Before the rough adjustment of the tape drive
train, check that the retaining guide height is
within the value in Figure 1-51 by using the special
jigs.
[Height adjustment of retaining guide1
Retaining &de height
adjusting Jg (JiGGIl - Fl8)
[Height adjustment of reverse guide;
Reverse guide height?
adjusting jig
To readjust the height, remove
the cut washer from behind. take
out the spring, lift the reverse
guide and sdd a washer.
25
of the retainlnp guide.
Figure l-51.
Reverse guide height
adjusting jig
Go-end is 13.52 mm.
Figure l-52.
Advertisement
Table of Contents
