Hydraulics; Crane Base: Checking The Oil Level/Oil Change - Jonsered 1250RZ Operator's Manual

8.5. Hydraulics

8.5.1. Crane base: checking the oil level/oil change

Checking the oil level in the crane base
1. The oil level must reach the bottom edge of the top oil
level eye. the crane slewing system and the lower
bearing of the column must be fully submerged in oil
bath.
2. If the oil level is below the minimum level, top up
through the filling hole with transmission oil of type MIL-
L-2105C or API-GL-5, viscosity SAE-80W-90
Changing oil in the slewing housing
Change the oil in the slewing house yearly!
1. Use a container with sufficient capacity to receive the oil. Drain off the oil through the drain
plug.
2. Refill through the hole for the measuring stick, with transmission oil of type MIL-L-2105C or
API-GL-5, viscosity SAE-80W-90.
3. Slew the crane, after filling to the end positions, three times.
4. Check the oil level. If necessary top up again.
Maintenance and Service
Jonsered 1250RZ -1500RZ safety+R CE 61