Cleaning The Freezer Parts; Sanitize Freezer And Freezer Parts; Assembly Of Freezer - Stoelting E131I Owner's Manual

3.9 CLEANING THE FREEZER PARTS

Place all loose parts in a pan or container and take to
the wash sink for cleaning. To clean freezer parts refer
to the following steps:
A. Place all parts in warm mild detergent water and
clean with brushes provided. Rinse all parts with
clean hot water.
B. Wash the hopper and freezer barrel with warm
detergent water and brushes provided.
C. Clean the rear seal surfaces from the inside of the
freezer barrel with warm detergent water .
Clean the auger drive socket located inside the
barrel at the rear seal area. Use clean cloth or
paper towel for this purpose.
D. Clean the drip trays and insert with a soap solution.
Rinse with clean hot water.

3.10 SANITIZE FREEZER AND FREEZER PARTS

A. Use a sanitizer mixed according to manufacturer's
instructions to provide a 100 parts per million
strength solution. Mix sanitizer in quantities of no
less than 2 gallons (7.5 liters) of 120°F water . Allow
the sanitizer to contact the surfaces to be sanitized
for 5 minutes. Any sanitizer must be used only in
accordance with the manufacturer's instructions.
B. Place all parts in the sanitizing solution, then remove
and let air dry.
C. Using this sanitizing solution and the large barrel
brush provided, sanitize the rear of the barrel and
drive area by dipping the brush in the sanitizing
solution and brushing the rear of the barrel.

3.11 ASSEMBLY OF FREEZER

To assemble the freezer part s , refer to the following
steps:
Petrol-Gel sanitary lubricant or equivalent must
be used when lubrication of parts is specified.
The United States Department of Agriculture and
Food and Drug Administration require that
lubricants used on food processing equipment
be certified for this use. Use lubricants only in
accordance with the manufacturer's instruc-
tions.
NOTE
NOTE
NOTE
A. Assemble all o-rings onto parts dry, without lubrica-
tion. Then apply a thin film of sanitary lubrication to
exposed surfaces of the O-rings. Apply a thin film
of sanitary lubricant to metal part of rear seal. Also
apply a thin film of sanitary lubricant inside the hole
of the front of the auger.
B. Assemble the rear seals onto the augers with the
large end to the rear. Be sure the O-ring is in place
before installing the rear seal.
C. Lubricate the inside of the auger drive sockets (rear)
with a small amount of white socket lubricant. A
small container of socket lubricant is shipped with
the freezer.
D. Screw the springs onto the studs in plastic flights.
Springs must be screwed into the flights com
pletely to provide compression (Fig. 22).
Figure 22. Exploded View of Auger
Do not place the mix inlet regulator into the hopper
before installing the auger. Attempting to install the
auger with mix inlet regulator in place will damage the
mix inlet regulator.
E. Install the two plastic flights onto rear of the auger
and insert part way into freezer barrel.
F. Install the third plastic flight, push the auger into the
freezer barrel and rotate slowly until the auger
engages the drive socket.
14
CAUTION