Cleaning The Freezer Parts; Sanitize Freezer And Freezer Parts - Stoelting SO212 Operator's Manual

D. Push the spigot body through the bottom of the
front door and remove.
E. Remove the front auger support and bushing (Fig.
3-6).
F. Remove the auger assembly from the freezer.
G. Keep the rear of the auger shaft tipped up once it
is clear of the freezer to avoid dropping rear seal.
H. Remove the scraper blades and the rear seal
assembly.
I. Wipe socket lubricant from the drive end (rear) of
the auger with a cloth or paper towel.
J. Remove all o-rings from parts by first wiping off
the lubricant using a clean paper towel. Then
squeeze the o-ring upward (Fig. 3-7). When a
loop is formed, roll out of the o-ring groove.
CAUTION
Do not use any type of sharp object to remove the
o-rings.
Figure 3-7 Removing O-Ring
3.9

CLEANING THE FREEZER PARTS

Place all loose parts in a pan or container and take to the
wash sink for cleaning. To clean freezer parts refer to the
following steps:
A. Place all parts in warm mild detergent water and
clean with brushes provided. Rinse all parts with
clean hot water.
If a dishwasher is used, product damage is likely to
occur.
B. Wash the hopper and freezer barrel with warm
detergent water and brushes provided. (Fig. 3-8)
Figure 3-8 Cleaning Freezer Barrel
C. Clean the rear seal surfaces from the inside of the
freezer barrel with warm detergent water.
D. Clean the drip tray and insert with a soap solution.
Rinse with clean hot water.
3.10 SANITIZE FREEZER AND FREEZER
PARTS
A. Use a sanitizing solution mixed according to
manufacturer's instructions to provide 100 parts
per million strength solution. Mix sanitizer in
quantities of no less than 2 gallons (7.5 liters) of
120°F water. Allow the sanitizer to contact the
surfaces to be sanitized for 5 minutes. Any sanitizer
must be used only in accordance with the
manufacturer's instructions.
B. Place all parts in the sanitizing solution, then
remove and let air dry.
12
NOTE