Porsche 7PP.971.675.J Manual page 40

Installing the connector fastener
Fig. 14 Distance between wall mount and connector
fastener
When installing the connector fastener, ensure a dis-
tance of 200 mm from the basic wall mount.
38
Fig. 15 Drilling dimensions
1. Remove the connector fastener (Fig. 15) from
1
the cover (Fig. 15).
2
2. Mark the drill holes on the wall.
3. Drill the mounting holes and insert wall plugs.
4. Screw the connector fastener (Fig. 15) onto
1
the wall.
5. Fit the cover (Fig. 15) onto the connector fas-
2
tener (Fig. 15) from below and push up.
1
Attaching the control unit to the wall
mount
Fig. 16 Attaching the control unit
1. Route the vehicle cable through the lower open-
ing of the basic wall mount, place the bottom of
the control unit on the locking tab and push back
to engage.
2. Guide the supply cable through the upper open-
ing in the basic wall mount and lock the circlip by
pushing it to the left.
3. Insert the vehicle plug in the connector fastener.