Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CompuLab Airtop3
Summary of Contents for CompuLab Airtop3
- Page 1 Owner’s Manual Revision 1.0 23-Apr-2019...
-
Page 2: Table Of Contents
Table of Contents Introduction ......................................3 Quick Start Guide ....................................4 Airtop3 hardware specifications ................................5 Airtop3 features ....................................7 Airtop3 devices and installation ................................9 BIOS ........................................12 Troubleshooting ....................................12 Safety instructions....................................13 Warranty and RMA .................................... 13 Regulatory Information ................................ -
Page 3: Introduction
4. HDMI to DVI adapter 5. Mini-serial to DB9-male adapter cable 6. 16x M3 screws for HDD To use Airtop3 you will need: A monitor with DisplayPort or HDMI/DVI input + DVI/HDMI cable adapter if needed • USB keyboard and mouse •... -
Page 4: Quick Start Guide
Tel: +972-48-290-168 www.fit-iot.com Quick Start Guide Several Airtop3 models are sold “Barebone” – without RAM and storage. To install RAM and storage please consult “Installation and Service” below. Choosing placement for Airtop3 Please consider the following when placing Airtop3 Do not place Airtop3 in a small closed space having no airflow •... -
Page 5: Airtop3 Hardware Specifications
Hayetsira St. 17, Yokneam, Israel Tel: +972-48-290-168 www.fit-iot.com Airtop3 hardware specifications Intel Core i9-9900K Or another pin-compatible 8 gen/9 gen CPU Chipset Intel C246 Chipset Up to 128 GB 4x UDIMM DDR4-2666 ECC | Non-ECC DDR4 ECC | non- Note: Buffered / registered RAM is not supported... - Page 6 10 cm (W) x 30 cm (H) x 25.5 cm (D) Weight 6 Kg to 9 Kg* Housing All aluminum housing & cooling Natural airflow cooling (fanless) Mounting Wall mounting bracket* * Sold separately DIN-rail mounting bracket* Page 6 of 14 www.fit-iot.com Airtop3 owner’s manual...
-
Page 7: Airtop3 Features
Hayetsira St. 17, Yokneam, Israel Tel: +972-48-290-168 www.fit-iot.com Airtop3 features I/O and internal devices Dimensions www.fit-iot.com Page 7 of 14 Airtop3 owner’s manual... - Page 8 Hayetsira St. 17, Yokneam, Israel Tel: +972-48-290-168 www.fit-iot.com Block diagram Page 8 of 14 www.fit-iot.com Airtop3 owner’s manual...
-
Page 9: Airtop3 Devices And Installation
The standard FACE Module of Airtop3 (FM-AT3) has a LED marked “R” for RAM. After RAM initialization the “R” LED changes color from amber to green. If Airtop3 does not boot, check “R” LED color. If color is not green there is a problem with RAM detection. - Page 10 NVMe / SSD Airtop3 supports 2x NVMe with a form factor of M.2 M-Key 2280 | 2260 | 2242 The NVMe devices each has PCIe x4 interface. The SSDs are installed by fastening each to the SSD cooling plate using the red spacer and a pan-head screw.
- Page 11 (down) Push the cartridge onto the left bracket and • hang it on the right bracket Close the cartridge ejector (lift yellow lever) • and press until it clicks into place. Page 11 of 14 www.fit-iot.com Airtop3 owner’s manual...
-
Page 12: Bios
By default Airtop3 ships with the FM-AT3 FACE Module that has 4 LEDs marked B, R, H, D Turn on Airtop3 and observe the R LED. Normally it would turn amber for a short period (during RAM detection) and upon successful detection it will turn green. -
Page 13: Safety Instructions
Warranty on the storage device is 24 months only • Warranty on the replaceable battery is 24 months only Your sole remedy and Compulab’s sole liability shall be for Compulab, at its sole discretion, to either repair or replace • the defective product at no charge This warranty is void if the product has been altered or damaged by accident, misuse or abuse •... -
Page 14: Regulatory Information
-Connect the equipment into an outlet on a circuit different party responsible compliance from that to which the receiver is connected. (Compulab Ltd.) could void the user’s -Consult the dealer or an experienced radio/TV technician for authority to operate the equipment. help. WEEE...