Advertisement
Step 8
A21 ctr
(112)
The wall panels come in two widths.
Each wall panel has a crimped rib
on one side. The crimped rib should
go under the rib of the panel that
follows it.
1
Locate all of the wall panels and
set each one alongside the building.
2
Be sure that you have the correct
panels in each position. Do this by
overlapping the panels and determin-
ing if the holes line up with the holes
in the frame.
3
Fasten the wall panels at the top
and bottom with screws.
4
Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs as before.
5
When you have attached all wall
panels in the correct positions, the
building will look like this.
STEP
(17)
9364
8995
9364
STEP
3
Use bolts and
STEP
nuts thru wall
angle overlaps
5
at the top of
panel at sides
and rear.
Parts Needed For
Wall Panels
1
Panels rest on
frame as shown
Crimped Rib
Underneath
21
9364 Wall Panel (4)
8995 Wall Panel (4)
8995 8995
Detail Showing
Center of Panel Screwed
to Wall Channel
STEP
4
STEP
2
9364
8995
9364
Bolt and nut
does not go thru
wall channel
at overlap
Advertisement
