Advertisement
Step 6
A19 ctr
(26)
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this
point if you do not have enough time to
complete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall
requires a washer.
CORRECT
INCORRECT
1
Position a corner panel at the
corner of the oor frame as shown.
The widest part of each corner panel
must be placed along the side of the
building for all four corners. Fasten
the corner panel to the oor frame
with one screw.
Support the corner panel with a step
ladder until a wall panel is attached.
2
Attach the front wall panels to
the front corner panels, as shown.
A small gap will exist between front
wall panel and ramp.
3
Attach the wall panels to the rear
corner panels, as shown.
NOTE
Be careful to install the correct
panel in each position as shown
4
Double-check the part numbers of
the wall panels, before proceeding.
The oor frame must be square
and level or holes will not align.
Parts Needed For
(4)
STEP
4
Corners
9362
Wide Side
SIDE
STEP
9362
1
8995
9372
9362
9362
9372
Panels rest on
frame as shown
19
8995 Wall Panel (2)
9372 Front Wall Panel (2)
9362 Corner Panel (4)
Narrow
Side
REAR
TOP VIEW
FRONT
STEP
3
STEP
2
8995
8995
9362
9372
9362
SIDE
9362
8995
9372
Crimped Rib
Underneath
9362
Washer
Advertisement
