Table of Contents
Advertisement
Figure 70. Lowering the processor into the socket
b. After the system processor module is properly aligned, press the top of the pen to release it from
the processor. Lift the pen off the processor.
5. If either the TIM or the heat sink is damaged, replace both the TIM and the heat sink. The TIM is
pre-applied to the heat sink. Carefully lower the heat sink over the system processor module,
ensuring that the holes in the heat sink (A) align with the two guide pins (B) on the socket, as shown
in Figure 71.
Figure 71. Installing the heat sink
60
Power Systems: Servicing the IBM Power System S821LC (8001-12C) or the IBM CS821 (8005-12N)
Advertisement
Table of Contents
