IBM CS821 Service Manual page 20

Figure 1. Removing a drive
4. Support the bottom of the drive as you slide it out of the system. Do not hold the drive by the
handle.
5. If you are removing more than one drive, repeat the steps in this procedure until all drives are
removed.
6. Remove a drive from the tray.
v For a 3.5-inch drive, unfasten the drive from the sides of the tray by removing four screws (2 on
each side), as shown in Figure 2 on page 5.
4
Power Systems: Servicing the IBM Power System S821LC (8001-12C) or the IBM CS821 (8005-12N)