Table of Contents
Advertisement
Figure 14. Installing the disk drive backplane
5. Fully insert the front drive trays. For instructions, see "Replacing a disk drive in the 8001-12C,
8001-22C, 8005-12N, or 8005-22N system" on page 6.
6. Using the labels, replace the drive signal cables (A), (B), and drive power cable (C) into the system
backplane as shown in Figure 15 on page 17. Ensure that the cable latch clip snaps into place on the
connector.
16
Power Systems: Servicing the IBM Power System S821LC (8001-12C) or the IBM CS821 (8005-12N)
Advertisement
Table of Contents
