Table of Contents
Advertisement
Figure 65. Removing the heat sink
6. Place the heat sink upside down on a clean surface.
7. Inspect the system processor socket area and remove any dust or debris (use a can of compressed
air).
8. Lower the vacuum pen tool onto the system processor module. Fully press the top of the pen (A)
and hold the pen in the center of the processor module as shown in Figure 66. Release the top of the
pen to fasten the pen onto the processor module.
Note: To prevent the system processor module from falling, do not press the tip while holding the
pen and the system processor module. Minimize the time and distance that you have the pen
holding the system processor module in case the vacuum seal releases early.
Figure 66. Locking the vacuum pen to the system processor module
Removing and replacing parts
57
Advertisement
Table of Contents
