Extreme Networks ExtremeSwitching 5420 Series Hardware Installation Manual page 81

Installing Your Switch
Working carefully, one port at a time, do the following:
1. Verify that you have identified the correct cable for the port.
2. Use an alcohol wipe or other appropriate cleaning agent to clean the cable connectors; make sure
they are free of dust, oil, and other contaminants.
3. If you are using optical fiber cable, align the transmit (Tx) and receive (Rx) connectors with the
correct corresponding connectors on the switch or the I/O module.
4. Press the cable connectors into their mating connectors on the switch or I/O module until the cable
connector is firmly seated.
5. Repeat the preceding steps for the remaining cables on this or other switches or I/O modules.
6. Dress and secure the cable bundle to provide appropriate strain relief and protection against bends
and kinks.
ExtremeSwitching 5420 Series Hardware Installation Guide
Connecting Network Interface Cables
81