Check After Power-On; Connecting The Ap To The Network - H3C WA6636 Installation Manual

Figure2-15 Using a power adapter to connect the AP to a local power source

Check after power-on

Examine the LEDs on the AP after you power on it to verify that the AP is operating correctly. For
more information about the LEDs, see "LEDs."

Connecting the AP to the network

All AP settings are configured on the AC. To verify network connectivity of the AP, execute the
display wlan ap all
to the network.
<AC> display wlan ap all
Total number of APs: 1
Total number of connected APs: 1
Total number of connected manual APs: 1
Total number of connected auto APs: 0
Total number of connected common APs: 1
Total number of connected WTUs: 0
Total number of inside APs: 0
Maximum supported APs: 3072
Remaining APs: 3071
Total AP licenses: 128
Remaining AP licenses: 127
State : I = Idle,
C = Config,
AP name
ap1
command on the AC. If the AP status is R/M, the AP has been connected
AP information
J = Join, JA = JoinAck,
DC = DataCheck, R = Run
APID State Model
1 R/M WA6636
2-8
IL = ImageLoad
M = Master, B = Backup
Serial ID
219801A2K2819CE00001