Table of Contents
Advertisement
Port
10/100/1000M Ethernet
copper port
(GE2/PoE_OUT)
Power port (54 V)
Reset button
USB port
LEDs
Table4-2 LED descriptions
LED
Standards and
protocols
IEEE802.3
N/A
N/A
USB 3.0
Status
Off
Steady on
Yellow
Flashing at 2 Hz
Steady on
Green
Flashing at 0.5 Hz
Flashing at 2 Hz
Blue
Flashing at 1 Hz
Description
Used for connecting a downlink device. It can also
supply PoE power to the downlink device.
It is represented by interface number GE1/0/2 in the
MAP file and GigabitEthernet 2 for configuration on
the AC.
Used for receiving +54 VDC power from a local
power source.
•
To reset the AP, press and hold the button for
no more than 5 seconds.
•
To restore the factory default, press and hold
the button for more than 5 seconds.
N/A
Description
No power is present or the LED has been turned off
from the CLI.
The AP is initializing, or an initialization exception
has occurred.
The Ethernet interfaces are down and no mesh links
are established.
The AP has registered to an AC, but does not have
any associated clients.
The AP has started up but has not registered to any
AC.
The AP is upgrading the image.
The AP has associated clients.
4-2
Advertisement
Table of Contents
