Table of Contents
Advertisement
6.
Verify that the AP is securely installed to prevent it from falling off.
Connecting the AP to a power source
You can supply power to the AP by using a local power source or through 802.3af/802.3at/802.3bt
PoE as required. Before powering the AP, make sure the local power source or the power sourcing
equipment (PSE) is reliably grounded.
Connecting a PoE power source
CAUTION:
The AP is to be connected only to PoE networks without routing to the outside plant.
IMPORTANT:
The 10GE port on the device supports 802.3af-, 802.3at-, and 802.3bt-compliant PoE, and the GE
port onthe device supports 802.3af- and 802.3at-compliant PoE. You can supply power to the
device through the 10GE port and GE port at the same time.
To power the AP through PoE, use an Ethernet cable to connect an Ethernet port on a PoE switch to
the 10GE/PoE++ port on the AP.
Figure2-14 Powering the AP through PoE
Connecting a local power source
You can use an AC/DC power adapter to connect the AP to a local power source. No power adapter
is provided with the AP. Prepare one yourself as required.
specifications.
Table2-1 Power adapter specifications
Item
Input
Output
Output power
Table2-1
Specification
100 VAC to 240 VAC
+54 VDC
≤40W
2-7
describes the power adapter
at 0.74 A
Advertisement
Table of Contents
