Check After Power-On; Connecting The Ap To The Network - H3C WA6638 Manual

Figure 2-15 Connecting a power injector

Check after power-on

Examine the LEDs on the AP after you power on it to verify that the AP is operating correctly. For
more information about AP LEDs, see "LEDs."

Connecting the AP to the network

To connect the AP to the network, connect the 10GE/PoE++ port on the AP to an Ethernet switch.
All AP settings are configured on the AC. To verify the network connectivity of the AP, execute the
display wlan ap all
to the network.
<AC> display wlan ap all
Total number of APs: 1
Total number of connected APs: 1
Total number of connected manual APs: 1
Total number of connected auto APs: 0
Total number of connected common APs: 1
Total number of connected WTUs: 0
Total number of inside APs: 0
Maximum supported APs: 64
Remaining APs: 63
Total AP licenses: 16
Local AP licenses: 16
Server AP licenses: 0
Remaining Local AP licenses: 15
Sync AP licenses: 0
State : I = Idle,
C = Config,
AP name
ap1
command on the AC. If the AP status is R/M, the AP has been connected
AP information
J = Join, JA = JoinAck,
DC = DataCheck, R = Run,
APID State Model
1 R/M WA6638
2-8
IL = ImageLoad
M = Master, B = Backup
Serial ID
219801A24F8191E00166