Figure2-6 Inserting the security screw
5.
Insert the screws through the installation holes in the mounting bracket into the holes in the
wall. Fasten the screws to secure the mounting bracket to the wall, as shown in Figure2-7.
Figure2-7 Attaching the mounting bracket to the wall
6.
Position the four pegs at the AP rear into the keyhole slots in the mounting bracket and then
slide the AP down until it clicks into place, as shown in Figure2-8.
Figure2-8 Attaching the AP to the mounting bracket
7.
Use a security Torx screwdriver to fasten the M3 × 23.5 security screw.
2-4