Advertisement
3.2.3 Disassembly of [17] MONITOR ASSY
CAUTIONS
(1) During the procedure, be careful in handling the parts.
Be very careful not to damage or stain the LCD screen.
If fingerprints are left on the screen, wipe them off with
clean chamois leather or a cleaning cloth.
Removing MONITOR ASSY
(1) Remove the 2 screws (1, 2).
(2) Turn the HINGE UNIT ASSY 90°, and remove the 2 screws
(3, 4).
(3) Remove the MONI.COVER ASSY by releasing the 7
hooks (L17a-g).
(4) Release the lock of the connector (CN17a), and remove
the HINGE UNIT ASSY by lifting it up.
During the procedure, be careful in handling the FPC.
(5) Remove the MONITOR BOARD ASSY and the BRACK-
ET (LCD) as one unit.
(6) Release the lock of the connector (CN17b), and pull out
the FPC.
(7) Remove the 2 screws (5,6), and remove the MONITOR
BOARD ASSY .
(8) Refer to the drawing for disassembly of MONI SA.
NOTE17a:
MONI SA consists of the parts on both sides of the
LCD CASE.
On one side of the LCD CASE, the SHEET (BEF),
SHEET (M/DIFF), LIGHT GUIDE, and the SHEET
(M.REF) are assembled toward the MONITOR
BOARD ASSY. On the other side, the SHEET LCD,
LCD MODULE, and the SPACER LCD are assembled
in order between the LCD CASE and the BRACKET
(LCD).
NOTE17b:
During the procedure, be careful in handling the parts.
Be very careful not to damage the FPC.
NOTE17c:
To attach the SHEET (M/DIFF), insert the SHEET (M/
DIFF) under the ribs on the LCD CASE.
Removing HINGE UNIT ASSY
(1) Remove the HINGE COVER(U).
(2) Remove the HINGE COVER(L).
NOTE17d:
During the procedure, be careful in handling the FPC.
The FPC, with its connection to the MONITOR BOARD
ASSY facing inward, is rolled around the axis (shaft) of the
HINGE UNIT ASSY rotation 2.5 rounds (2.5times).
(3) Remove the MAGNET.
NOTE17e:
The FPC, with its connection to the MONITOR
BOARD ASSY facing inward, is rolled around the axis
(shaft) of the HINGE UNIT ASSY rotation 2.5 rounds
(2.5times).
During the procedure, be careful in handling the MAG-
NET.
When attaching, set the N pole outside as shown in
the figure. Be careful when removing as there is no
marking.
(No.YF335<Rev.001>)1-25
Advertisement
