Installation Space; Single Outdoor Unit Installation - Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual

3. INSTALLATION SPACE

● The installation space shown in the following examples is based on an ambient temperature under
cooling operation of 35 °C DB at the air intake of the outdoor unit.
Provide more space around the air intake than shown in the examples if the ambient temperature
exceeds 35 °C DB or if the thermal load of all of the outdoor units exceeds the capacity.
● Consider the transportation route, installation space, maintenance space, and access, and install
the unit in a location with sufficient space for the refrigerant piping.
● Observe the installation space specifications that are shown in the figures.
Provide the same space for the air intake at the rear of the outdoor unit.
If the installation is not performed according to the specifications, it could cause a short circuit and
result in a lack of operating performance.
As a result, the outdoor unit might easily be stopped by high-pressure protection.
● When there is a wall at the right side of the unit,provide a space of 100mm or more.
Front
Air intake
● Installation methods not shown in the following examples are not recommended.
Performance may drop significantly.

3-1. SINGLE OUTDOOR UNIT INSTALLATION

„ WHEN THE UPWARD AREA IS OPEN
„
z Obstacles at rear only
„
100 or more
z Obstacles at front only
„
1000 or more
„ WHEN AN OBSTRUCTION IS PRESENT ALSO IN THE UPWARD
„
AREA
z Obstacles at rear and above only
„
Max.
500
1000 or
more
100 or
more
*
: When side walls are protruding frontward, refer to "3-4. DUCT INSTALLATION".
Caution
Rear
- (03 - 05) -
z Obstacles at rear and sides only
80 or
more
300 or
more
100 or more
z Obstacles at front and rear only
100 or more
1000 or more
z Obstacles at rear, sides, and above
*
only
80 or
more
100 or more
Unit : mm
*
1500 or
more
300 or
more