Signal Amplifier Automatic Address Setting - Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual

Hide thumbs Also See for AIRSTAGE J-III L AJ 072LELAH Series:

Table of Contents

1-5-1. SIGNAL AMPLIFIER AUTOMATIC ADDRESS SETTING

● The Signal Amplifier Automatic Address Setting function can be used for a maximum of 40

signal amplifiers installed within the same network.

● Perform the automatic address setting of signal amplifiers on only one outdoor unit (master

unit) within the same network. (Do not set them again from other outdoor unit.)

● When setting the address of a signal amplifier automatically, be sure to always set the

address on the printed circuit board of the Signal amplifier to "1"(factory setting).

● Please perform automatic address setting after checking that filter mode setting of Signal

amplifier is completed.

1) After verifying that the system is normally, press the MODE/EXIT button (SW107) once.

2) Press the SELECT button (SW108) to display "F3" on the LED104.

(Monitoring mode)

(The display of the LED104 changes each time the SELECT button is pressed.)

*1 : The "F1" and "F9" modes are used for maintenance, so do not set them in regular

3) When "F3" appears on the LED104, press the ENTER button (SW109).

A flashing display appears on the LED105.

4) Press the SELECT button (SW108) to display "10" on the LED105.

5) When "10" appears on the LED105, hold down the ENTER button (SW109) for at least 3

seconds. (Unless it is held down for at least 3 seconds, the selection will not be confirmed.)

When the Automatic Address Setting function is activated, the display changes to "run."

(Setting mode)

(Function mode)

(Error history mode)

Show Quick Links

Table of Contents