Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 641

 To protect the compressor of the outdoor unit, carefully read and understand the following cautions that may affect
the operation of the compressor before executing the setting.
 When performing periodical settings like schedule settings for the following functions, perform the setting to all the
„
indoor units in the same refrigerant system simultaneously, conforming to the timing restriction described below.
<Corresponding function>
· Start operation
· Release indoor unit forced
thermostat off mode
 Forced thermostat OFF instruction
 Only one equipment can send these instructions for each refrigerant system.
„
 When these instructions are sent by multiple equipment, the system may not respond as instructed or may
„
malfunction.
„ SPECIFICATIONS
„
Power supply
Input Power (W)
Dimensions [H × W × D] (mm)
Weight (g)
z Recommended operating environment
„
Temperature(°C)
Humidity (%)
z Transmission specifications
„
Transmission speed
Cable
Network connector
More than 10 minutes must elapse
More than 10 minutes must elapse
1ø AC 208-240 V 50/60 Hz
Operating
Packaged
Packaged
®
BACnet / IP (ASHRAE 135 Annex J)
10 / 100 Mbps
Ethernet category 5 or higher STP
RJ45
- (05 - 173) -
· Stop operation
· Set indoor unit forced thermostat
off mode
4.6
60 x 270 x 176
1200
0 to 46
-10 to 60
5 to 95 (RH) ;
No condensation