Fujitsu AIRSTAGE J-III L AJ 072LELAH Series Design & Technical Manual page 807

„ ADDRESS SETTING „
z Indoor unit address setting „
5) Pressing the SET BACK button, select a remote controller address (select the indoor unit
you want to operate).
6) Pressing the SET TIME < button or the SET TIME > button, display function number 01.
7) Pressing the SET TEMP. V button or the SET TEMP. Λ button, set up the indoor unit
address. (The setting range is from 00 to 63.)
8) Pressing the TIMER SET button, confirm the selected indoor unit address data.
(The data will be transferred to the indoor unit.)
● When indoor unit address data was not set
up on the indoor unit (-- is displayed.)
● Set up indoor unit address data again
according to the procedure in step 7) above.
Remote controller address
Ex.) When remote controller address "01" is
selected
Function number
Indoor unit address data
Ex.) When indoor unit address data "12" is set up
ERROR
When indoor unit address data was normally set
up on the indoor unit
(Flashing display changes to illuminated display.)
- (07-26) -
GOOD